MicoAir405 V2 Flight Controller - top view

MicoAir405 V2 Flight Controller

Rs. 3,799.00
Skip to product information
MicoAir405 V2 Flight Controller - top view

MicoAir405 V2 Flight Controller

Rs. 3,799.00
Share on WhatsApp

The MicoAir405 V2 is a 30.5 x 30.5mm F405 flight controller built for ArduPilot and INAV, with a Bosch BMI088 IMU, a barometer, and dual 5V/9V regulators. It suits multirotors, fixed-wing and rovers that need GPS navigation, mission flying and autonomous modes, at a lower cost than an H7 board.

This listing is the flight controller only, with no ESC. If you want it paired with a matching 4-in-1 ESC, see the MicoAir405 V2 Bluejay Stack.

Features

  • STM32F405RGT6 (168MHz, 1MB flash) with a Bosch BMI088 IMU
  • SPL06 barometer for altitude hold
  • AT7456E analog OSD
  • microSD slot for blackbox logging
  • 10 PWM outputs: DShot on outputs 1–8, bidirectional DShot on 1–4
  • Dual regulators: 5V 3A and 9V 3A
  • Dedicated 6-pin connector for a DJI O3 air unit

Specifications

MCU STM32F405RGT6, 168MHz, 1MB flash
IMU Bosch BMI088
Barometer SPL06
OSD AT7456E (analog)
Compass None onboard. Add an external compass over I2C.
Blackbox microSD card slot
UARTs 6 (UART6 RX inverted for SBUS)
PWM outputs 10
Other interfaces I2C, USB Type-C
Input voltage 2–6S LiPo
Regulators (BEC) 5V 3A, 9V 3A
Mounting 30.5 x 30.5mm (ø4mm holes)
Size 36 x 36 x 8mm
Weight 9g
Firmware ArduPilot (4.5.0+), INAV (8.0+)

Compatibility

  • No ESC included. On a quad, pair it with a 30.5 x 30.5mm 4-in-1 ESC. On a plane, use individual ESCs and servos.
  • No compass onboard. Return-to-home and autonomous modes need a GPS module with a compass.
  • Video: analog through the onboard OSD, or a DJI O3 air unit through the 6-pin connector, which supplies 9V.
  • Firmware: this is the BMI088 ArduPilot/INAV board. It is not a Betaflight board.

Works with (available at AeroFlow)

In the box

  • 1x MicoAir405 V2 flight controller

You may also like