NewBeeDrone BeeID v1.1 M10Q GPS Module with Remote ID & Drone Tracker
Rs. 3,499.00
Skip to product information
NewBeeDrone BeeID v1.1 M10Q GPS Module with Remote ID & Drone Tracker
Rs. 3,499.00
The NewBeeDrone BeeID v1.1 M10Q combines three functions on one lightweight board: a high-performance M10Q GNSS receiver, a Remote ID broadcast transmitter, and a Bluetooth LE drone-tracker beacon.
As a GPS it uses the u-blox M10Q chipset with a high-gain ceramic antenna and 72-channel parallel tracking, giving fast satellite lock for Betaflight GPS Rescue and autonomous navigation. The BLE tracker beacon keeps transmitting after a crash, so you can walk a downed quad down on your phone using apps such as Drone Scanner even after losing video and control link. A built-in barometer supplies altitude for broadcast reporting only — it does not participate in flight control.
Note on Remote ID: the Remote ID function is certified to FAA requirements for aircraft over 250g in US airspace. India has its own separate DGCA regulations, so this module should not be treated as Indian regulatory compliance. The GPS and tracker functions work anywhere.
Key features
- High-precision u-blox M10Q GPS
- Built-in BLE drone tracker for recovery
- FAA-compliant Remote ID broadcast
- Lightweight and compact (approx. 5.2g)
- Ceramic GPS antenna
- WiFi setup via phone or PC
- Standard UART interface
- Built-in barometer for Remote ID altitude broadcast
Specifications
| Dimensions | 22 x 15.6 x 8mm |
|---|---|
| GPS module | M10Q |
| Protocol | GPS L1, GLONASS L1, GALILEO E1 |
| Weight | 5.2g |
| Antenna | ceramic |
| Receiving channels | 72 |
| Bitrate | 115200bps |
| Speed accuracy | 0.05 m/s |
| Dynamic characteristics | 50,000m |
| Operating temperature | -40°C to +85°C |
| Connectivity | WiFi for configuration; BLE for Remote ID broadcast |
| Power | 5V input and ground |
| Compatibility | Betaflight, INAV, ArduPilot, PX4 |
Setup
- Connect BeeID TX to FC RX, and BeeID RX to FC TX on the same UART port
- Connect 5V power and ground
- Set the UART baud rate to 115200bps and enable GPS mode
- Save and reboot the flight controller
Compatibility
- GPS only - no compass. Good for GPS Rescue and crash recovery; INAV navigation modes need a separate compass.
- One UART: GPS, Remote ID and tracker all run over a single FC UART plus 5V.
- Size: 22 x 15.6mm, 5.2g - fits 3-5" builds.
- Regulatory: Remote ID is to US FAA rules - not a DGCA compliance device in India.
Works with (available at AeroFlow)
- FC / stacks: SpeedyBee F405 V5, SpeedyBee F405 Mini, GEPRC TAKER F722 AIO
Important for INAV users: disable the AUTO-CONFIG setting for the BeeID module to function correctly. Ensure your flight controller firmware supports the UBLOX GPS protocol.