Foxeer M10Q 180 V2 GPS & IST8310 Compass Module
Rs. 2,399.00
Skip to product information
Foxeer M10Q 180 V2 GPS & IST8310 Compass Module
Rs. 2,399.00
The Foxeer M10Q 180 V2 is a GPS module with an integrated IST8310 compass, built on the u-blox M10050 chip for faster, more accurate positioning than older M8-chip modules. At 18x18x8mm it strikes a good balance of size and antenna sensitivity, suited to standard 5" drones and cinewhoops.
This is an original, official Foxeer product supplied in unbranded packaging (no logos) — fully authentic, just plain packaging.
Specifications
| Chip | u-blox M10050, 72 channels |
|---|---|
| Constellations | GPS L1, GLONASS L1, BDS B1, Galileo E1, SBAS L1, QZSS L1 |
| Compass | IST8310 |
| Input voltage | 5V |
| Baudrate | 115200bps, protocol UBLOX (NMEA also supported) |
| Output frequency | 10Hz |
| Speed accuracy | 0.05m/s, position accuracy: 2D 1.5m |
| Weight | 7.5g, size: 18x18x8mm |
Compatibility
- Wiring: TX/RX to a free FC UART (crossed), 5V and GND; IST8310 compass on the FC's I2C pads (SDA/SCL).
- Firmware: Betaflight 4.3 or newer, INAV (mag alignment usually CW 90° flip for IST8310), ArduPilot.
- Size: 18 x 18mm, 7.5g - 3.5-5" freestyle and cinewhoops.
Works with (available at AeroFlow)
- Foxeer FC: Foxeer F722 V4
- Stacks: SpeedyBee F405 V5, GEPRC TAKER F722 BT