RadioLink D460 Turbot Flying Wing

The RadioLink D460 Turbot is a compact flying wing that comes ready to fly straight out of the bag. Servos, motor, ESC and the Byme-DB flight controller are factory-installed and set up, so there is no assembly or parameter tuning: charge the battery, plug it in and launch. The Byme-DB's three flight modes take a new pilot from self-levelling Stabilize mode through to fully Manual flight, and the light EPP airframe (EPO-style finish) takes knocks without breaking. It ships in RadioLink's carry bag with shoulder strap, so the plane, radio and charger travel together.

Features

• 3 flight modes on CH5 – Stabilize (self-levelling, bank limited to 70° and pitch to 45°), Gyro (rate mode) and Manual
• Byme-DB flight controller – 3-axis gyro + 3-axis accelerometer, SBUS/PPM compatible
• Ready out of the box – no assembly or parameter setup
• Durable EPP airframe with an EPO-style finish
• Up to ~30 min flight time on the included 2S 800mAh pack
• Up to 4km range with real-time battery-voltage telemetry (RTF)
• Light – 155g take-off weight
• Carry bag included – padded bag with shoulder strap for the plane and accessories

Specifications

Versions

• RTF – plane, battery, T8S transmitter, R8XM receiver and CM210 charger: everything you need to fly
• PNP – plane and battery with Byme-DB, motor, ESC and servos installed; add your own transmitter, receiver and 2S charger

In the box

• D460 Turbot flying wing with Byme-DB, motor, ESC and 2 servos installed
• 7.4V 2S 800mAh LiPo battery
• 2 × GEMFAN 7035 propellers with rubber band
• Cross screwdriver, spare control horn and fibre tape
• Instruction manual
• Carry bag with shoulder strap
• RTF only: RadioLink T8S transmitter, R8XM receiver, CM210 2S balance charger, T8S charging/update cable

Works with (available at AeroFlow)

• Step up to vertical take-off and 3D: RadioLink A560 3D Aerobatic RC Airplane (same T8S radio and Byme family)